Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End

Description

• As these boards are made for 3D printers, the installation process for them is very simple. Once you have connected the control wires, you will need to connect the DC +/- terminals to your printer’s power supply. This is where you will want to use wires with a crimped connection as opposed to bare wires to reduce the risk of any short circuits.
• Next, insert you heated bed or hot end wires into the terminals labeled “HOT BED” and you’re all set. We would also recommend you use crimp terminals for the end of the wire that goes to the MOSFET as its screw terminals are better suited to these connectors.